Icom iC-M605 - Page 64

54
8
DSC OPERATION
New2001
[Ignore]*:
Ignores the Call and returns to the
Main screen.
* Displayed only when “Single” is selected
in the PROCEDURE menu. (p. 62)
[Hold]:
Holds the RX call task, and returns
to the Main screen.
[ACK (Unable)]:
Sends an acknowledgment with no
position and time data.
[ACK (Able)]:
Sends an acknowledgment with
position and time data.
[Accept]:
Enters the DSC Task mode.
DSC Task mode (pp. 29, 30)
• Rotate [CH/ENT] to view the call contents.
4. Push [Standby] to return to
the Main screen.
TIP: See page 42 for details of
sending an acknowledgement.
1. When a Test call is received:
• Alarm sounds.
• The following screen is displayed
and the backlight blinks.
• “
” blinks.
2. Push any [Alarm Off] .
3. Select your action.
NOTE: When “Test ACK” is set to
“Auto,” the transceiver automatically
replies to the call. Both the TX and RX
calls are stored in the Transmitted and
Received Call Logs. (Default: Auto)
D Receiving a Test call
1. When a Position Request call is
received:
• Alarm sounds.
• The following screen is displayed
and the backlight blinks.
2. Push any [Alarm Off] .
3. Select your action.
D Receiving a Position
Request Call
NOTE: When “Position ACK” is set to
“Auto,” the transceiver automatically
replies to the call. Both the TX and RX
calls are stored in the Transmitted and
Received Call Logs. (Default: Manual)
■ Receiving DSC calls (Continued)