Icom IC-M91D - Channel Name Programming; Basic Operation

16
5
BASIC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Channel name programming ■
Each channel can be assigned a unique alphanumeric ID of
up to 10 characters.
Capital letters, 0 to 9, some symbols (! " # $ % & ' ( ) * + , – .
/ [ \ ] ^ _ : ; < = > ?) and space can be used.
Push [ q ∫](CH) or [√](CH) to select a channel.
• First, cancel the Dualwatch, Tri-watch or Scan function, if acti-
vated.
Push [NAME] to open the channel name programming w
screen.
• A black box is displayed on the fi rst character.
Enter the desired channel name in the following manner: e
• Select a desired character using [∫]/[√]/[Ω]/[≈].
• Push [ENTER].
• To move the cursor, select either arrow, “←” or “→,” then push
[ENTER].
• Select “SPACE,” then push [ENTER] to input a space.
• Select “DELETE,” then push [ENTER] to delete a character.
• Push [CLEAR] to cancel and return to the previous screen.
Repeat step re to input all characters.
Push [ t Ω]/[≈]/[∫]/[√] to select “FINISH,” then push [EN-
TER] to set and return to the previous screen.