Icom IC-M91D - DSC Operation - Position and Test Calls; Transmitting Position Report Calls; Transmitting Test Calls

28
8
DSC OPERATION
N
ew
2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Transmitting DSC calls ■
To ensure correct operation of the DSC function, make
sure you correctly set the CH70 SQL LEVEL. (p. 68)
Transmitting an individual call D
The Individual call function allows you to transmit a DSC sig-
nal to only a specifi c station.
Enter “INDIVIDUAL CALL” in the DSC CALLS menu. q
❮MENU❯ ➪ ❮DSC Calls❯ ➪ ❮Individual Call❯
(Push [MENU]) (Push [Y]/[Z] , then push [ENTER].)
Select the desired preprogrammed individual address, or w
“Manual Input,” using [Y]/[Z], then push [ENTER].
• The ID code for the Individual call can be set fi rst. (p. 20)
• When “Manual Input” is selected, set a desired 9 digit MMSI ID
code for the individual you wish to call.
About Manual Inputting:
Enter a desired individual ID in the following way:
• Select a desired number using [Y]/[Z]/[Ω]/[≈].
• Push [ENTER] to set it.
• To move the cursor, select either arrow, “←” or “→,” then push
[ENTER].
• The fi rst digit is specifi ed as ‘0’ for a Group ID. If a Group ID is
entered, an error beep sounds after pushing [FINISH].
• The fi rst two digits are ‘0’ for any coast station ID.
Select Routine, Safety or Urgency as the desired call type e
using [Y]/[Z], then push [ENTER].
NOTE: When a coast station is selected in step w, the
voice channel is automatically specifi ed by the coast sta-
tion. Therefore, skip step r and go directly to step t.