61
8
DSC OPERATION
ew
e
D Receiving a Polling Request call
When a Polling Request call is received:
➥ The alarm sounds for 2 minutes.
➥ “RCVD POLLING REQUEST” pops up. The LCD backlight
blinks for 2 minutes.
Push [ALARM OFF] to stop the alarm and the blinking q
backlight.
• If [ALARM OFF] is not pushed within 2 minutes, the next screen
may appear, depending on the received Category.
Push a softkey to select your desired action. w
[IGN]
➥ Push to ignore the Call and return to the normal operat-
ing mode.
• The transceiver exits the DSC mode.
• “ ” continues to blink and the Call is stored in the Received
Call Log.
[INFO]
➥ Push to display the Received call informati
on. (p. 63)
[ACK]
➥ Push to display the “POLLING REPLY” screen to reply
to the Call
. (p. 49)
When “POSITION ACK” is set to “Auto TX,” the transceiver
automatically replies to the Call. In that case, both the TX
and RX calls are stored in the Transmitted and Received
Call Logs.
To Next Page
Loading...
Need help?
General
