Icom IC-M91D - DSC Operation - Address IDs; Programming Individual DSC IDs

20
8
DSC OPERATION
DSC address ID ■
Programming Individual ID D
A total of 100 DSC address IDs can be programmed and as-
signed a name of up to 10 characters.
Enter “INDIVIDUAL ID” in the DSC SETTINGS menu. q
Push [ADD]. w
• The “INDIVIDUAL ID” program screen is displayed.
Enter a desired individual ID in the following way: e
• Select a desired number using [Ω]/[≈].
• Push [ENTER] to set it.
• To move the cursor, select either arrow, “←” or “→,” then push
[ENTER].
The fi rst digit is specifi ed as ‘0’ for a Group ID.
The fi rst two digits are ‘0’ for any Coast station ID.
Repeat step re to enter all 9 digits.
After entering the 9 digit code, push [ENTER] to set it. t
• The ID name programming screen is displayed.
Enter a desired 10 digit ID name in the following way: y
• Select a desired character using [∫]/[√]/[Ω]/[≈].
• Push [ENTER] to set it.
• To move the cursor, select either arrow, “←” or “→,” then push
[ENTER].
• Push [123] then [!$?] then [ABC] to select a character group.
After entering the ID name, push [ u ∫]/[√]/[Ω]/[≈] to select
“FINISH,” then push [ENTER] to program it.
• The “INDIVIDUAL ID” list screen is displayed.
Push [MENU] to exit the MENU screen. i
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
❮MENU❯ ➪ ❮DSC Settings ❯ ➪ ❮ Individual ID ❯
(Push [MENU]) (Push [Y]/[Z] , then push [ENTER].)