Idis TR-4316 - Alarm-In; Video Loss

Part 2 - Conguration
41
Alarm-In
• No.: Enable / disable alarm-ins.
• Title: Use the virtual keyboard to enter titles.
• Type: Change the alarm-in type.
• Actions: Specify which actions to take when Alarm-In
is detected.
– Record: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
– Alarm-Out: Designate event-triggered alarm-out
channels and beeps.
– Notify: Congure to be notied of events by Mail,
LAN1 through 5, FTP, Push, and/or Alert Window.
– PTZ: Moves the PTZ camera to a specic preset
position when an event occurs.
In order to use the Callback feature, the DVR must be
registered on the remote program.
Video Loss
• Video Loss Interval: The system does not produce
event log entries or issues remote notications
regarding video loss detected during the specied
time following the initial video loss detection. Set a
value between 0.1 sec and 15 secs or choose Never.
• Actions: Specify which actions to take when a Video
Loss event occurs.
– Record: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
– Alarm-Out: Designate event-triggered alarm-out
channels and beeps.
– Notify: Congure to be notied of events by Mail,
LAN1 through 5, FTP, Push, and/or Alert Window.
– PTZ: Moves the PTZ camera to a specic preset
position when an event occurs.
In order to use the Callback feature, the DVR must be
registered on the remote program.
• Use Ignoring Time: Select Time Setup to specify the
video loss detection ignore time. Video loss detection
will be disabled during the specied time frame.