Idis TR-4316 - Video Blind

Part 2 - Conguration
42
Video Blind
• Sensitivity: Allow you to adjust the DVR’s sensitivity
to video blind for Black and White independently from
0 (Never) and 1 (least sensitive) to 15 (most sensitive).
Video blind might NOT be detected for a camera
with a very noisy image especially when set for low
sensitivity values.
• Activation Time: Allow you to set the duration before
the DVR will report a Video Blind. The DVR will not
consider any blinded camera to be a Video Blind if the
detected blindness is less than the Activation Time set
on this screen.
• Actions: Specify which actions to take when video
blind events occur.
– Record: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to Event or Time & Event mode, the selected
cameras will begin linked recording when an event
occurs.
– Alarm-Out: Designate event-triggered alarm-out
channels and beeps.
– Notify: Congure to be notied of events by Mail,
LAN1 through 5, FTP, Push, and/or Alert Window.
– PTZ: Moves the PTZ camera to a specic preset
position when an event occurs.
In order to use the Callback feature, the DVR must be
registered on the remote program.
• Use Ignoring Time: Select Time Setup to specify
the video blind detection ignore time. Video blind
detection will be disabled during the specied time
frame.