AFL-08B-N270 User Manual
Page 42
Figure 2-13: Secure the Panel PC
2.6.2 Panel Mounting
To mount the AFL-08B-N270 panel PC into a panel, please follow the steps below.
Step 1: Select the position on the panel to mount the panel PC.
Step 2: Cut out a section from the panel that corresponds to the rear panel dimensions
of the panel PC. Take care that the panel section that is cut out is smaller than
the overall size of the metal frame that surrounds the panel PC but just large
enough for the rear panel of the panel PC to fit through (
Figure 2-14).
To Next Page
Loading...
Need help?
General
