C-COM Satellite Systems Inc. Page 65 of 164
3: Re- acquire Satellite in 15 minutes
DANGER: The system may try to deploy if this option is selected and vehicle
becomes in motion. Unattended option must be disabled when vehicle is moving
and system is NOT powered off.
5 – Inclined Orbit (Sat_Inc)
Enabling this option will allow the system to maintain signal with an inclined
orbital satellite. The user may select the time difference between each re-peak
on the inclined orbital satellite without disabling the transmitter and maximizing
on the signal strength. If signal strength drops before the re-peaking time is due,
the system will automatically re-peak to maintain signal strength. Feature
enhanced and will be used with regular Ka services to maintain strong signal
when platform shifts. This option will not work properly if Motion Protection is
enabled at the same time, disable Motion Protection when inclined option is
enabled.
DIS: Disabled
1: Re-peak every 10 minutes
2: Re-peak every 30 minutes
3: Re-peak every 1 hours
4: Re-peak every 2 hours
5: Re-peak every 3 hours
6: Re-peak every 4 hours
7: Re-peak every 6 hours
8: Re-peak every 8 hours
9: Re-peak every 12 hours
6 – Motion Protection
iNetVu
®
Platform will automatically stow if the antenna detects extreme motion,
such as severe shaking caused by poor weather conditions. If the shaking/shift is
in small increments the system will not stow assuming signal is not lost. If the
small motion/movement count (12 small movements in 30 seconds) logged in a
specific time window exceeds the set threshold the system will re-peak if signal
exists or stow if signal lost. System will redeploy if stowed due to environment
condition and “unattended Operation” is enabled, system will try to redeploy
according to configured unattended time.
D - Disabled
E - Enabled
7 – DHCP Status
The 7000 Series Controllers can be programmed to obtain an IP address from a
DHCP Server (i.e. modem, router, etc.)
D – DHCP Disabled (IP must be entered statically)
E – DHCP Enabled (Controller will dynamically obtain an IP address from the DHCP Server)