Infinite DVX Plus Mach I - Flash; Flash Key on Intercom; Flexible Button Programming

34 Flash
If you call a busy station :
1. Pres s the pre-programmed EXECUTIVE OVERRIDE flexible
button. The Executive station will be bridged onto th e CO
conversation in progress at the called station. An optional
warning tone is heard and presented to a ll parties prior to
cut- thru.
2. Replace handset at Executive station to terminate the
override.
Flash
When connected to an outside line:
Pres s the FL ASH bu tton to disconnect th e ou ts ide line
and reseize an outside line dial tone.
8-button telephones can assign a FLASH button by using
the code [660].
Flash Key on Intercom
When connected to a page zone or another internal party:
Press the FLASH button to disconnect page or intercom
call. An intercom dial tone will be heard.
Flexible Button Programming
To program a flexible button:
1. Press the SPEED button twice.
2. Press button to be programmed (must be programmed
in databa se as a flexib le button).
3. Dial the desired code (refer to the Default Numbering Plan
at the end of this user guide).