Intercom Ca lls 37
4. The called station then presses the flashing intercom
button to answer th e incoming intercom call. Once the
call is answered, the following message displays on the
called station LCD as shown.
Intercom Calls
Answering an Intercom Call
When your intercom button signal switch is in the:
H Mode (No LED) -- Handsfree Mode. You will hear three
bursts of tone and an announcement. Reply handsfree or
lift handset for privacy.
P Mode (LED Flash ing) -- Privacy Mode. You will hear
three bursts of tone and a one-way announcement. The
calling party cannot hear conversations in progress.
T Mode (LED On) -- Tone Mode. You will hear repeated
bursts of intercom tone ringing and the HOLD b utton will
slow flash. Lift handset or press ON/OFF button to
answer.
Intercom Transfer
Intercom transfer without DSS buttons:
1. Receive or make an intercom call.
2. Press the TRANS button. An intercom dial tone sounds.
3. Dial th e station wh ere ca ll is to b e transferred.
When 2nd station answers, you are in a Supervised
Tran sfer mode. (1st station is staged for transfer.)
4. Replace the handset. (Station 1 and 2 are connected)
CALL FROM STA XXX
MMM DD YY HH:MM am
To Next Page
Loading...