38 Keyset Mode
Intercom transfer using DSS buttons:
1. Receive or make an intercom call using a DSS button.
2. Press the TRANS button. Intercom dial tone is heard.
3. Press the DSS button w here call is to b e transferred.
4. Replace the handset. (Station 1 and 2 are connected)
Pla cing an Int ercom Call
1. Pres s the pre-programmed DSS button of the party to be
called or dial their th ree-d igit station number.
You will hear ringing if the called station’s button is in the
“T” position; or three bursts of tone if in the “H” or “P”
position.
2. Lift the handset or use the speakerphone after the tone
bursts stop.
3. Hang up to end the call.
Keyset Mode
This feature allows you to determine the mode and baud rate
of the optional CTI Module connected to your phone. This
setting is stored in back-up memory in the case of a power
outage or system reset.
Dialing a number in t he numbering plan activates
the telepho ne a utomat ically.
To Next Page
Loading...