40 LCR Operation
3. Press the [#] key to scroll through the baud rates.
Available Baud rates are: 1200, 2400, and 4800.
4. Press the HOLD button to save the desired entries.
LCR Operation
To place an outside call when LCR is enabled in the system:
1. Dial [9].
2. Dial th e d esired 7-dig it teleph one number (e.g., 1 + area
code + number).
3. Wait for answer. Lift the handset or use the speakerphone
to conv erse with the pa rty.
LCR Queue Call Back
If an LCR Queue Call Back is activated:
1. When teleph one is signaled, ans wer the call. Desired
telephone num ber will automa tically be redialed.
2. Wait for answer, then lift the handset or use the
speakerphone to converse with the party.
To Cancel an active LCR Queue:
1. Dial th e LCR Queue Cancel code [626].
2. Replace the handset or press the ON/OFF button.
Selec t the CK TU Mode fo r Wanderer Cor dless Ha ndset
operation. The baud rate is not used in this mode; no
changes are necessary.
If the 911 Feature is active, [8] + [0] is the LCR access
code, not [9].
Onl y one LCR Qu eu e Ca ll Back request m ay be
initiated by a station. When a second request is made,
the first request will be canceled.
To Next Page
Loading...