54 PBX/Centrex Codes on a Flex Button
3. When the desired messag e is shown on the LCD d isp lay,
press HOLD to activate that message on your station. A
confirmation tone sounds; the DND button LED flashes.
PBX/Centrex Codes on a Flex Button
For easy one-button access to Centrex or PBX features, perform
the following step s:
1. Program the Centrex or PBX code into a Station or System
Speed Dial bin, including hook-flash (FLASH key), [
6
],
and [#] commands (refer to “Storing Speed Numbers” on
page -56).
2. Program that speed bin onto a flexible button (refer to
“Flexible Button Programming” on page 3 4. )
Repeat Redial
A keyset station user places a CO call and receives a busy or no
answer:
1. Pres s the pre-programmed REDIAL flexible button. The
LCD prompts you for a timer value as shown:
2. Enter a three-digit timer value (006-999 seconds) for the
redial timer. Default value is 060 (one minute). A
confirmation tone sounds and you go on-hook. The
flexible button LED lights steady. When the timer expires,
the station is signaled via a CO line queue indication on
the REDIAL flexible button. Once the line queue is
answered, the LCD indicates an outgoing CO line display.
ENTER RPT REDIAL TIMER;
XXX 006-99 9
❑
Flex
Btn
To Next Page
Loading...