Keys et Mode 39
When telep hone is set to AT comma nd m ode, these AT
commands are supported.
At an idle station:
1. Dial the Keyset Mode code [648] or press the pre-
programmed KEYSET MODE button. The display shows:
2. Pres s the [
6
] k ey to s croll through the keyset modes. The
available modes are: Inactive, PC Phone, ATD, ATH, and
CKTU Comm and modes.
Table 1: AT Command Modes
Mo de Descr ipt ion
Inactive No CTI information is sent/received by the telephone.
ATD Modem Dialing Command -- The telephone will
recognize the ATD and accept digits after the
command.
ATH or ATHX
(X= 0 or 1)
Modem On-Hook/Off-Hook Command -- ATH or ATH0
will force the telephone to go to the on-hook state
from its current state. ATH1 will force the telephone to
go to the off-hook state from it’s current state.
CKTU Command used with Wanderer (a cordless key
telephone unit).
PC Phone CTI information used with Dis cover y Deskto p and
Discovery PCPhone software must be set to 4800 baud
rate.
If the handset is
off-hook (lifted)…
Commands are discarded and no action is taken by the
telephone.
AT o r AT Z
(X= 0 or 1)
Modem Reset/Initialize Command -- Whenever these
commands are sent to the keyset, the keyset will return
OK in ASCII format.
INACTIVE 2400
MODE=
6
SAVE=HOLD BAUD=#
To Next Page
Loading...