Infors HT Multitron - Page 104

Multitron - Operating Manual
Operation
Page 102 of 158 20 August 2020
10. Tap the Plus or Minus key in the corresponding setting key area
to set the desired setpoint values and switch the parameters on
using the ON/OFF key.
Starting the timer
11. Tap the TIMER key when all settings for the second phase are
correct
On the alphanumeric displays the messages Strt (upper) and
OFF
(lower) appear. In the lower display area the white sign
Setpoint
is lit up. This means that the timer function can now be started.
In the separate timer display area the sign
Timer is lit up.
12. Tap the ON/OFF key in the lower setting key area to start the
timer function.
On the alphanumeric displays the messages Strt (upper) and
run
(lower) appear. In the lower display area the white sign
Setpoint
is lit up. The display then changes to showing the remaining
time of the first phase on the upper and the message
run
on the
lower alphanumeric display.
In the separate timer display area the sign
Timer is lit up. The
blue sign
Phase 1 is blinking.