Integra CUSA Clarity System - Guidance and Manufacturers Declarations

This document contains proprietary and confidential information of Integra LifeSciences Corporation. Integra’s confidential information may not be used, disclosed or reproduced without the prior wrien consent of Integra LifeSciences Corporation.
CUSA® Clarity System Service and Maintenance Manual Page 92 of 117 0645403-2-EN
EMC Information
Note
The CUSA Clarity system should not be used adjacent to or stacked with equipment other than the equipment specified in the CUSA Clarity
Ultrasonic Surgical Aspirator System Operator’s Manual. If adjacent or stacked use is necessary, the CUSA Clarity system should be observed to verify
normal operation in the configuration in which it will be used.
The use of accessories, other than the accessories specified in this manual, may result in increased emissions or decreased immunity of the CUSA
Clarity system.
10.10 Guidance and Manufacturer’s Declarations
Guidance and Manufacturer’s Declaration – Electromagnetic Emissions
The CUSA Clarity system is intended for use in the electromagnetic environment specified below.
The customer or the user of the CUSA Clarity system should assure that it is used in such an environment.
Emissions test Compliance Electromagnetic Environment - Guidance
RF emissions
CISPR 11
Group 1
The CUSA Clarity system uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely to cause any
interference in nearby electronic equipment.
RF emissions
CISPR 11
Class A The CUSA Clarity system is suitable for use in a hospital environment.
Harmonics emissions
IEC 61000-3-2
Not Applicable
Not applicable for hospital environments
Voltage fluctuations / flicker
emissions
IEC 61000-3-3
Not Applicable