Integra DTR-20.1 User Manual

33
Connecting the AV receiver—Continued
With u (Remote Interactive), you can use the following special functions:
■ Auto Power On/Standby
When you start playback on a component connected via u, if the AV receiver is on Standby, it will automatically
turn on and select that component as the input source. Similarly, when the AV receiver is set to Standby, all
components connected via u will also go on Standby.
■ Direct Change
When playback is started on a component connected via u, the AV receiver automatically selects that component
as the input source.
■ Remote Control
You can use the AV receiver’s remote controller to control your other u-capable Integra/Onkyo components. You
must enter the appropriate remote control code first (see page 81). And remember to point the remote controller at
the AV receiver and not the other component.
Notes:
• Use only u cables for u connections. u cables
are supplied with Integra/Onkyo players (DVD, CD,
etc.).
• Some components have two u jacks. You can
connect either one to the AV receiver. The other jack
is for connecting additional u-capable
components.
• Connect only Integra/Onkyo components to u
jacks. Connecting other manufacturer’s components
may cause a malfunction.
• Some components may not support all u functions.
Refer to the manuals supplied with your other
Integra/Onkyo components.
• While Zone 2 is on, the Auto Power On/Standby and
Direct Change u functions do not work.
• Before connecting the power cord, connect all your speakers and AV components.
• Plug the end of the power cord into a suitable wall outlet.
• Turning on the AV receiver may cause a momentary power surge that might interfere with other electrical equipment
on the same circuit. If this is a problem, plug the AV receiver into a different branch circuit.
Connecting Integra/Onkyo u Components
Step 1: Make sure that each Integra/Onkyo component is connected to the AV receiver with an analog audio cable
(RCA).
Step 2: Make the necessary u connections (see illustration below).
LR
IN
CD
L
R
ANALOG
AUDIO OUT
LR
ANALOG
AUDIO OUT
e.g., CD player
e.g., DVD player
Connecting the Power Cord
DTR-20.1_En_A.book Page 33 Wednesday, April 8, 2009 10:06 PM

Integra DTR-20.1 Specifications

General

Brand	Integra
Model	DTR-20.1
Category	Receiver
Language	English