81
Controlling Other Components—Continued
Remote Control Codes for Integra/Onkyo
Components Connected via
u
Integra/Onkyo components that are connected via u
are controlled by pointing the remote controller at the
AV receiver, not the component. This allows you to
control components that are out of view, in a rack, for
example.
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, or you want
to control an Integra/Onkyo component that’s not
connected via u, use the following remote control
codes:
• [DVD/BD] button
30627:
Integra/Onkyo DVD player without
u
(default)
• [CD] button
71817:
Integra/Onkyo CD player without
u
(default)
•[TV] button
11807:
Integra/
Onkyo TV (default)
If you want to control an
Integra/
Onkyo component by
pointing the remote controller directly at it, use the
following remote control codes:
32900:
Integra/
Onkyo BD player
32901:
Integra/
Onkyo HD-DVD player
70868: Onkyo MD player
71323: Onkyo CD recorder
82990: Onkyo RI Dock
Note:
If you connect an u-capable Onkyo RI Dock to the
TV/Tape IN, Game IN or VCR/DVR IN jacks, for u to
work properly, you must set the Input Display
accordingly (see page 41).
Resetting the Remore Mode Buttons
You can reset a Remote Mode button to its default
remote control code.
You can reset the remote controller to its default settings.
1
Make sure the Integra/Onkyo component
is connected with an u cable and an
analog audio cable (RCA).
See page 33 for details.
2
Enter the appropriate remote control code
to the Remote Mode button.
• [DVD/BD] button
31612: Integra/Onkyo DVD player with u
•[CD] button
71327: Integra/Onkyo CD player with u
•[TV/Tape] button
42157: Onkyo cassette recorder with u
(default)
• [Port] button
82351: Onkyo Dock
• [Tuner] button
51805: To control the AV receiver’s tuner
(default)
See the previous page for how to enter remote
control codes.
3
Press the Remote Mode button, point the
remote controller at the AV receiver, and
operate the component.
1
While holding down the Remote
Mode button that you want to
reset, press and hold down the
[Audio] button until the Remote
indicator lights up (about 3
seconds).
2
Within 30 seconds, press the
Remote Mode button again.
The Remote indicator flashes twice,
indicating that the button has been
reset.
Each of the Remote Mode buttons is
preprogrammed with a remote control
code. When a button is reset, its
preprogrammed code is restored.
Resetting the Remote Controller
1
While holding down the
[Receiver] button, press and hold
down the [Audio] button until the
Remote indicator lights up
(about 3 seconds).
2
Within 30 seconds, press the
[Receiver] button again.
The Remote indicator flashes twice,
indicating that the remote controller
has been reset.
(3 seconds)
(3 seconds)
DTR-20.1_En_A.book Page 81 Wednesday, April 8, 2009 10:06 PM
To Next Page
Loading...
Need help?
General
