Integra DTR-20.1 User Manual

39
First Time Setup—Continued
If you connect a video component to a COMPONENT
VIDEO IN, you must assign that input to an input
selector. For example, if you connect your DVD player
to COMPONENT VIDEO IN 2, you must assign
COMPONENT VIDEO IN 2 to the DVD/BD input
selector.
Notes:
• If you connect an input component (such as UP-A1
series Dock that seated iPod) to the UNIVERSAL
PORT jack, you cannot assign any input to Port
selector.
• This procedure can also be performed on the AV
receiver by using its [Setup] button, arrow buttons, and
[Enter] button.
Component Video Input Setup
Input selector Default assignment
DVD/BD IN1
VCR/DVR -----
CBL/SAT IN2
Game -----
TV/Tape -----
CD -----
Port -----
1
Press the [Receiver] button,
followed by the [Setup] button.
2
Use the Up and Down [q]/[w]
buttons to select “1.Input
Assign”, and then press [Enter].
Setup
Receiver
qwer
Enter
3
Use the Up and Down [q]/[w]
buttons to select
“1-2.Component”, and then
press [Enter].
4
Use the Up and Down [q]/[w]
buttons to select an input
selector, and use the Left and
Right [e]/[r] buttons to select:
IN1: Select if the video component
is connected to
COMPONENT VIDEO IN 1.
IN2: Select if the video component
is connected to
COMPONENT VIDEO IN 2.
-----: Select if you’re not using the
COMPONENT VIDEO
OUT.
5
Press the [Setup] button.
Setup closes.
DTR-20.1_En_A.book Page 39 Wednesday, April 8, 2009 10:06 PM

Integra DTR-20.1 Specifications

General

Brand	Integra
Model	DTR-20.1
Category	Receiver
Language	English