34
Turning On the AV receiver
On/Standby
On/Standby
Receiver
Standby indicator
Turning On and Standby
On the AV receiver, press the [On/Standby] button.
On the remote controller, press the [Receiver] button, followed by the
[On/Standby] button.
The AV receiver comes on, the display lights up, and the Standby indicator goes off.
To turn the AV receiver off, press the [On/Standby] button, or press the remote
controller’s [On/Standby] button. The AV receiver will enter Standby mode. To prevent
any loud sur prises the next time you turn on the AV receiver, turn down the volume
before you turn it off.
Remote
controller
AV receiver
or
Up and Running in a Few Easy Steps
To get your system up and running with the minimum of fuss, here’s a few pointers to help you configure the AV
receiver before you use it for the very first time. These settings only need to be made once.
■ Do the 2EQ Room Correction and Speaker Setup—this is
essential!
See “Audyssey 2EQ™ Room Correction and Speaker Setup” on page 35.
■ Did you connect a component to an HDMI input,
component video input, or digital audio input?
If you did, see “HDMI Input Setup” on page 38, “Component Video
Input Setup” on page 39, or “Digital Input Setup” on page 40
respectively.
■ Did you connect an Onkyo RI Dock?
If you did, see “Changing the Input Display” on page 41.
OPTICAL
COAXIAL
Y
P
B
PR
HDMI
OUT IN
TV/TAPE
RI Dock
DTR-20.1_En_A.book Page 34 Wednesday, April 8, 2009 10:06 PM
To Next Page
Loading...
Need help?
General
