Integra DTR-20.1 User Manual

61
Advanced Setup
Note:
This procedure can also be performed on the AV receiver
by using its [Setup] button, arrow buttons, and [Enter]
button.
This section explains how to check the speaker settings and how to set them manually, which is useful if you change a
speaker after performing the Audyssey 2EQ™ Room Correction and Speaker Setup.
Some of the speaker settings are set automatically by the Audyssey 2EQ Room Correction and Speaker Setup function
(see page 35).
Common Procedures in Setup Menu
Setup
Number
Buttons
Receiver
qwer
Enter
Remote
indicator
1
Press the [Receiver] button followed by
the [Setup] button.
2
Use the Up and Down [q]/[w] buttons to
select main menu, and then press [Enter].
3
Use the Up and Down [q]/[w] buttons to
select the function, and then press the
[Enter] button.
4
Use the Up and Down [q]/[w] button to
select item, and then use the Left and
Right [e]/[r] buttons to set them.
5
When you’ve finished, press the [Setup]
button.
Setup closes.
Speaker Setup
2-1. Sp Config (Speaker Configuration)
These settings are set automatically by the Audyssey 2EQ Room Correction and Speaker Setup function (see page 35).
With these settings, you can specify which speakers are connected and a crossover frequency for each speaker. Specify
“FullBand” for speakers that can output low frequency bass sounds adequately, for example, speakers with a good sized
woofer. For smaller speakers, specify a crossover frequency. Sounds below the crossover frequency will be output by
the subwoofer instead of the speaker. Refer to your speaker’s manuals to determine the optimum crossover frequencies.
Note:
Speaker Configuration and Double Bass settings cannot be changed while headphones are connected.
Subwoofer Yes: Select if a subwoofer is connected (default).
No: Select if no subwoofer is connected.
Front
*1
Full Band, 40Hz, 45Hz, 50Hz, 55Hz, 60Hz, 70Hz, 80Hz, 90Hz, 100Hz (default), 110Hz,
120Hz, 130Hz, 150Hz, 200Hz
Center
*2
Surr
*2
SurrBk
*3*4
Full Band, 40Hz, 45Hz, 50Hz, 55Hz, 60Hz, 70Hz, 80Hz, 90Hz, 100Hz, 110Hz, 120Hz,
130Hz, 150Hz, 200Hz
None: Select if no speaker is connected.
DTR-20.1_En_A.book Page 61 Wednesday, April 8, 2009 10:06 PM

Integra DTR-20.1 Specifications

General

Brand	Integra
Model	DTR-20.1
Category	Receiver
Language	English