Integra DTR-20.1 User Manual

80
Controlling Other Components
You can control your DVD player, CD player, and other
components with the AV receiver’s remote controller.
To control another component, you must first enter that
component’s remote control code to a Remote Mode
button.
This section explains how to enter remote control codes
and how to control your other components.
The following Remote Mode buttons are
preprogrammed with remote control codes for
controlling the components listed. You do not need to
enter a remote control code to control these components.
For details on controlling these components, see the
pages indicated.
Integra/Onkyo DVD/BD player (page 83)
Integra/Onkyo CD player (page 86)
Onkyo cassette recorder with u (page 88)
Onkyo Dock (pages 51, 87)
You’ll need to enter a code for each component that you
want to control.
Note:
The remote control codes provided are correct at the time
of printing but subject to change.
Preprogrammed Remote Control
Codes
Entering Remote Control Codes
Receiver
Display
Remote
Mode
Number
buttons
Remote
indicator
1
Look up the component’s remote
control code in the separate
Remote Control Codes list.
The codes are organized by category.
2
While holding down the Remote
Mode button to which you want
to enter a code, press and hold
down the [Display] button until
the Remote indicator lights up
(about 3 seconds).
Notes:
• Remote control codes cannot be
entered for the [Receiver] and
[Zone 2] buttons.
• Only TV remote control codes can be
entered for the [TV] button.
• Apart from the [Receiver], [TV], and
[Zone 2] buttons, remote control
codes from any category can be
entered for the Remote Mode
buttons. However, these buttons also
work as input selector buttons
(page 42), so choose a Remote Mode
button that corresponds with the
input to which you connect your
component. For example, if you
connect your CD player to the CD
input, choose the [CD] button when
entering its remote control code.
3
Within 30 seconds, use the
number buttons to enter the 5-
digit remote control code.
The Remote indicator flashes twice.
If the remote control code is not entered
successfully, the Remote indicator will
flash once slowly.
(3 seconds)
DTR-20.1_En_A.book Page 80 Wednesday, April 8, 2009 10:06 PM

Integra DTR-20.1 Specifications

General

Brand	Integra
Model	DTR-20.1
Category	Receiver
Language	English