75
Zone 2—Continued
Note:
This procedure can also be performed on the AV receiver
by using its [Setup] button, arrow buttons, and [Enter]
button.
■ Z2 Out
If you’ve connected your Zone 2 speakers to an amp with
no volume control, set the “Z2 Out” setting, respectively,
to “Variable” so that you can set the zone’s volume, bal-
ance, and tone on the AV receiver.
■ Z2 MaxVol
With this setting, you can limit the maximum volume for
Zone 2. The Maximum Volume range is “Off”, 30 to 79.
■ Z2 POnVol
This setting determines what the volume will be for Zone
2 each time the AV receiver is turned on.
The range is “Last”, “Min”, 1 to 79 or “Max”.
To use the same volume level that was used when the AV
receiver was turned off, select “Last”.
The “Z2 POnVol” cannot be set higher than the “Z2
MaxVol” setting.
This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust
the volume for Zone 2.
Controlling Zone 2 from the AV receiver
Notes:
• To select AM or FM, press the [Tuner] input selector
button repeatedly.
• Only analog input sources are output by Zone 2.
Digital input sources are not output. If no sound is
heard when an input source is selected, check to make
sure it’s connected to an analog input.
• While Zone 2 is on, the Auto Power On/Standby and
Direct Change u functions do not work.
5
When you’ve finished, press the
[Setup] button.
Setup closes.
Fixed: The Zone 2 volume must be set on the amp
in that zone.
Var iable : The Zone 2 volume can be set on the AV
receiver.
Using Zone 2
1
To turn on Zone 2 and select an
input source, press the [Zone 2]
button followed by an input
selector button within 8 seconds.
Zone 2 turns on and Zone 2 indicator
lights up.
To select the same source as that of the
main room, press the [Zone 2] button
repeatedly until “Z2 Sel: Source”
appears.
To select AM or FM press the [Tuner]
input selector button repeatedly.
Note:
You cannot select different AM or FM
radio stations for your main room,
Zone 2. The same AM/FM radio station
will be heard in each room.
2
To turn off Zone 2, press the
ZONE 2 [Off] button.
Zone 2
Off
Input Selector
Zone 2 indicator
70_Zone2_En.fm 75 ページ ２００９年４月９日 木曜日 午前９時２９分
To Next Page
Loading...
Need help?
General
