134 Intel
®
Modular Server System Service Guide
Steps to Manually Update the Modular Server System Date and Time
Note: Use the manual setting only if the network time server is not configured.
1. Click Settings > Date/Time in the left navigation panel.
2. Click the Calendar icon and follow the instructions in the bottom pane of the calendar.
Figure 85. Calendar
3. To change the date, click the buttons beneath the printed month to change the Year
and Month.
— Click the single right angle bracket (>) to increment to the next Month; click the
single left angle bracket (<) to decrement to the previous Month.
— Click the double right angle bracket (>>) to increment to the next Year; click the
double left angle bracket (<<) to decrement to the previous Year.
4. To change the time, click the values in the Hour, Minute and AM/PM box next to
Time as follows:
— To increment the Hour value, click the Hour value or drag the mouse to the right.
— To decrement the Hour value, hold the <Shift> key and click the Hour value or
drag the mouse to the left.
— To increment the Minute value, click the Minute value or drag the mouse to the
right.
— To decrement the Minute value, either hold the <Shift> key and click the Minute
value or drag the mouse to the left.
— Click am/pm to set the time in am or pm, as required.
The button toggles between the two options.
5. Click Save Changes.
In the Update dialogue box Update and Reboot. This action will reset the
management module to enable the changes to take effect.
To Next Page
Loading...
Need help?
General
