Intel Server Board SE7501HG2 Product Guide
116
System Cooling Fans Do Not Rotate Properly
If the system cooling fans are not operating properly, system components could be damaged.
Check the following:
! Is AC power available at the wall outlet?
! Is the system power cord properly connected to the system and the wall outlet?
! Did you press the power button?
! Is the power on light lit?
! Have any of the fan motors stopped (use the server management subsystem to check the fan
status)?
! Are the fan power connectors properly connected to the server board?
! Is the cable from the front panel board connected to the server board?
! Are the power supply cables properly connected to the server board?
! Are there any shorted wires caused by pinched cables or power connector plugs forced into
power connector sockets the wrong way?
If the switches and connections are correct and AC power is available at the wall outlet, contact
your service representative or authorized dealer for help.
Diskette Drive Activity Light Does Not Light
Check the following:
! Are the diskette drive’s power and signal cables properly installed?
! Are all relevant switches and jumpers on the diskette drive set correctly?
! Is the diskette drive properly configured?
! Is the diskette drive activity light always on? If so, the signal cable may be plugged in
incorrectly.
If you are using the onboard diskette controller, use the Setup Utility to make sure that “Onboard
Floppy” is set to “Enabled”. If you are using an add-in diskette controller, make sure that
“Onboard Floppy” is set to “Disabled”.
If the problem persists, there may be a problem with the diskette drive, server board, or drive signal
cable. Contact your service representative or authorized dealer for help.
Hard Disk Drive Activity Light Does Not Light
The hard disk drive activity light is not connected to the server board SE7501HG2.
To Next Page
Need help?
General
