Intel SE7501HG2 User Manual

Intel Server Board SE7501HG2 Product Guide
122
Clearing the CMOS
If you are not able to access the BIOS setup screens, the CMOS may need to be cleared. One of
two methods can be used to clear the CMOS: using a CMOS clear button sequence from the front
panel or using the CMOS clear jumper on the system board. Each of these methods is described
below.
Clearing CMOS with the Front Panel Buttons
Use the following steps to reset the CMOS by using the buttons on the front panel:
1. Power off the system, leaving the AC power connected.
2. Hold down the reset button for at least four seconds. Leave the button depressed while
continuing with the next step.
3. With the reset button still depressed, press the on/off power button.
4. At the same time, release both the on/off power button and the reset button.
Clearing CMOS with the CMOS Jumper
You can also reset the CMOS by moving a jumper on jumper block J1H1 of the system board. Use
the following steps to reset the CMOS by using the jumper.
1. Power down the system and disconnect the AC power.
2. Open the server.
3. Move the CMOS Clear jumper to the Force Erase position, covering pins 2 and 3 as indicated
in the following diagram.
TP00033
J1J1
J1H1
2
3
6
7
5
1
10
11
9
2
3
1
Figure 34. CMOS Recovery Jumper

Intel SE7501HG2 Specifications

General

Brand	Intel
Model	SE7501HG2
Category	Server Board
Language	English