Solving Problems
123
4. Reconnect the AC power, power up the system.
5. Press F2 and enter the BIOS Setup Utility. When BIOS Setup is loaded, press the F9 key and
Enter to return the parameters to the default values.
6. Modify any BIOS Setup values according to the desired system configuration.
7. Press F10 and Enter to exit BIOS Setup and save changes.
8. Power down the system and disconnect the AC power.
9. Return the CMOS Clear jumper to its original position, covering pins 1 and 2.
10. Close the server chassis.
To Next Page
Loading...
