Intel SE7501HG2 - 2 Server Board Installations and Upgrades; Tools and Supplies Needed; Before You Begin; Emissions Disclaimer

Intel Server Board SE7501HG2 Product Guide
30
2 Server Board Installations and Upgrades
Tools and Supplies Needed
• Phillips
*
(cross head) screwdriver (#1 bit and #2 bit)
• Flat blade screwdriver
• Needle nosed pliers
• A ruler
• Pen or pencil
• Antistatic wrist strap and conductive foam pad (recommended)
Before You Begin
Emissions Disclaimer
To ensure EMC compliance with your local regional rules and regulations, the final configuration
of your end system product may require additional EMC compliance testing. For more
information, please contact your local Intel Representative.
See “Regulatory and Integration Information” on page 129 for product Safety and EMC regulatory
compliance information. This is an FCC Class A device. Integration of it into a Class B chassis
does not result in a Class B device.
Safety Cautions
These warnings and cautions apply throughout this chapter. Only a technically qualified person
should configure the server board.
CAUTIONS
System power on/off: The power button DOES NOT turn off the system
AC power. To remove power from system, you must unplug the AC power
cord from the wall outlet. Make sure the AC power cord is unplugged before
you open the chassis, add, or remove any components.
Hazardous conditions, devices & cables: Hazardous electrical conditions
may be present on power, telephone, and communication cables. Turn off
the server and disconnect the power cord, telecommunications systems,
networks, and modems attached to the server before opening it. Otherwise,
personal injury or equipment damage can result.