Intel SE7501HG2 - Installation Procedures; Installing the I;O Gasket and Shield; Figure 3. Attaching the Gasket to the I;O Shield

Installations and Upgrades
33
Installation Procedures
Installing the I/O Gasket and Shield
✏
NOTE
An ATX 2.03-compliant I/O shield is provided with the server board. The
shield is required by Electromagnetic Interference (EMI) regulations to
minimize EMI. If the shield does not fit the chassis, obtain a properly sized
shield from the chassis supplier.
The shield fits the rectangular opening in the back of a chassis. The shield has cutouts that match
the I/O ports. Install the shield from inside the chassis.
Attaching the Gasket to the I/O Shield
1. Remove the two backing strips from the gasket.
2. Press the gasket onto the inside face of the I/O shield as shown.
TP00028
Figure 3. Attaching the Gasket to the I/O Shield