26
C700 - Marine Satellite Communication System
5.4 Mounting Antenna
The lower radome has two types of industry-standard mounting holes, each with four mounting points.
Select one of the two mounting types to secure the antenna to the desired mounting surface. Bring the
provided Antenna Mounting Template and the ADU Bolt Kit from the ADU package. Create the appropriate
hole pattern in the desired mounting surface for the chosen mounting bolts type.
5.4.1 Mounting Antenna using Inner Holes (with M6 Bolts)
First, remove the protective stickers on the Inner Holes. Check the position of
A
the antenna's cable
connector and BOW direction. Lift the antenna above the mounting surface using hands and carefully put
the antenna down in place. Before assembling bolts, apply Loctite #263 to the bolt's threads to ensure the
bolts are fastened rmly. Insert
B
the bolts and washers from under the mast into the radome then fasten
them to the nuts assembled inside the radome using the torque wrench.
5.4.2 Mounting Antenna using Outer Holes (with M10 Bolts)
First, remove the protective covers on the Outer Holes. Check the position of
A
the antenna's cable
connector and BOW direction. When placing the antenna on the mounting surface, be careful of the
direction of the cutting holes. Lift the antenna above the mounting surface using hands and carefully put the
antenna down in place. Before assembling bolts, apply Loctite #263 to the bolt's threads to ensure the bolts
are fastened rmly. Insert
B
the bolts and washers from under the mast into the radome then fasten them
to the nuts assembled inside the radome using the torque wrench.
BOW
Use a torque wrench.
x Four Times
M6 Flat Washer
M6 Spring Washer
M6 x 20L Hex. Bolt
A
B
Use a torque wrench.
M10 Flat Washer
M10 Spring Washer
M10 x 20L Hex. Bolt
B
x Four Times
BOW
A
Figure 14: Mounting Antenna using Outer Holes (with M10 Bolts)
Figure 13: Mounting Antenna using Inner Holes (with M6 Bolts)
To Next Page
Loading...
Need help?
General