Interlogix Advisor Advanced ATS2000A-MM - Page 101

Advisor Advanced ATSx000A(-IP) Installation and Programming Manual 91
#
Option
User group
Normal
user
Supervisor
Installer
Guard
27.
Schedule access
N (U)
Y (U)
[Y]
Y (U)
28.
Fob learning
N (U)
Y (U)
[Y]
N (U)
29.
Remote pics
N (U)
N (U)
N (U)
30.
Pic deletion
N (U)
N (U)
N (U)
31.
CS configuration
N (U)
Y (U)
[Y]
N (U)
Y/N :Default option value (yes or no)
[Y/N]: Option is read only.
(U): Option can be changed by a user programmable function. See “User programmable
functions” on page 193.
For detailed descriptions of user group options see “3.2.n.5 User group options”
below.
3.2.n.3 User group areas
3 UG areas
>1.......<
The User group areas option defines which areas the user can control.
3.2.n.4 User group filter
4>UG filter
Not used
When using a filter, the user rights defined by the user group depend on this filter
state.
For more information on condition filters, see “6.1 Condition filters” on page 117.
3.2.n.5 User group options
5>UG options
>>>
User group options define the user access rights to the particular options. The
following options can be configured.
Table 24: User group options as user privileges
#
Option
Description
1.
Full set
Set the premises.
2.
Part set 1
Perform a partial set 1.
3.
Part set 2
Perform a partial set 2.
4.
Unset
Unset.
5.
Inhibit
Inhibit zones.
6.
Isolate
Isolate zones, bus devices, cameras etc.
7.
Time and date
Change system time and date.