146 Advisor Advanced ATSx000A(-IP) Installation and Programming Manual
8.2.4.13 Do reset
The Do reset command is used to perform the engineer reset.
8.2.4.14 Custom text
Use custom text to program a prompt displayed when an engineer reset is
required.
If the custom text is not set, the standard prompt will be displayed as described in
“Engineer reset procedure” on page 143.
Otherwise, the prompts will be the following, depending on a user code display or
warning message:
See “Engineer reset procedure” on page 143 for more information.
8.2.5 Cancel in.time
5 Cancel in.time
Disable?
The Cancel installer in-time menu lets you disallow the Installer in function before
the Installer in-time expires (see “8.1.3.6 Installer in-time” on page 141).
Note: This option is only valid if the installer requires a user authorization. See
“8.2.1 User code required” on page 143.
Use this function after the panel programming is complete. To cancel the installer
in-time, go to this menu and press Enter. Next, log out. After this, the installer log
in requires another user confirmation.
See also “User code requirement” on page 35.
8.2.6 Challenge code
Use this menu to activate challenge code functionality. See “Challenge code
requirement” on page 35 for more details.
Caution: Once activated, this option cannot be deactivated by software settings.
To Next Page
Loading...
Need help?
General
