50 Intermec EasyCoder ESim v4.00—Programmer’s Reference Manual
Chapter 7—Commands
D – Density, cont.
Recommended density settings are identifi ed in the following tables.
Further adjustments might be necessary depending on print speed, bar
code density, orientation, and ambient temperature/humidity conditions.
Direct Thermal Printing
Label/Tag Type Rec. Density
at Speed S = 2
Max. Speed
Duratherm II D10 S3
Duratherm II Tag D9 S1
Duratherm Lightning D9 S3
Duratherm IR D7 S3
Thermal Top D8 S3
Thermal Eco D8 S3
Thermal Top Board D11 S2
Thermal Eco Board D7 S2
Thermal IR D12 S3
Thermal Top High Speed D6 S3
To Next Page
Loading...
