How to prevent transfer ribbon wrinkles in my Intermec Printer?
To prevent transfer ribbon wrinkles in your Intermec Printer, check: * **Faulty ribbon break shaft adjustment:** Adjust the shaft. * **Incorrect edge guide adjustment:** Adjust the edge guide. * **Too strong print- head pressure:** Adjust the print-head pressure.
Why is the printout missing along the inner edge on my Intermec EasyCoder PF4i?
If the printout is missing along the inner edge on your Intermec Printer, consider these causes: * **Bad media alignment:** Adjust the media alignment. * **Small core & supply post in upper pos.:** Move the post to lower pos. * **X-start parameter value too low:** Increase the value.
Why is the text or bar code compressed on my Intermec Printer?
If the text or barcode appears compressed when printed from your Intermec Printer, it may be due to a print speed that is too high for the large media roll. Try lowering the print speed.
Why is there no thermal transfer printout from my Intermec EasyCoder PF4i Printer?
If there's no thermal transfer printout from your Intermec Printer, make sure the ink-coated side of the ribbon faces the media. Reload the ribbon if necessary.
General| Print technology | Direct thermal |
|---|---|
| Maximum resolution | 203 x 203 DPI |
| Standard interfaces | RS-232, USB 2.0 |
| Internal memory | 16 MB |
| Power consumption (standby) | 15 W |
| Power consumption (printing) | 300 W |
| Media thickness | 3/7.5 mm |
| Maximum label width | 104 mm |
| Maximum label length | 0.4 m |
| Maximum roll diameter | 152.4 /213 mm |
| Maximum internal memory | 1 GB |
| Supported network protocols | TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II |
| Product color | Blue, Silver |
| Storage temperature (T-T) | -20 - 70 °C |
| Operating temperature (T-T) | 40 - 104 °F |
| Operating relative humidity (H-H) | 20 - 80 % |
Weight and Dimensions| Depth | 405 mm |
|---|---|
| Width | 244 mm |
| Height | 178 mm |
| Weight | 8000 g |
Crucial safety information and precautions for safe operation.
Detailed overview of the printer's features and capabilities.
How to connect the printer to power and computers.
Step-by-step guide to powering on the printer.
Loading media for tear-off operation.
Loading media for use with the automatic paper cutter.
Loading self-adhesive labels for peel-off dispensing.
Instructions for loading the thermal transfer ribbon.
How to enter and use the printer's setup menu.
Detailed configuration options for printer operation.
Configuring serial port settings like Baud Rate and Parity.
Adjusting media feed for accurate printing.
Defining media size and type for optimal printing.
Selecting direct thermal or thermal transfer printing settings.
Resetting printer settings to their original default values.
Detailed setup flow for the UART1 serial port configuration.
Detailed setup flow for media parameters like type and size.
Detailed setup flow for print definition parameters.
Understanding the printer's status indicator lights.
Troubleshooting based on error messages and LED status.
Common print quality issues and their solutions.
Procedures for cleaning the printer's printhead.
Instructions for replacing the printhead.
Steps to clear jammed media from the printer.
How to adjust and test the label detection sensor.
Adjusting the pressure of the printhead for optimal print quality.
Details on the serial communication port and its protocol.
Information about the USB connection and requirements.
Recommended ribbon types for thermal transfer printing.
To Next Page