Intermec PB22 User Manual

Chapter 1 — Using the PB22 and PB32 Mobile Label and Receipt Printer
PB22 and PB32 Mobile Label and Receipt Printer User Guide 25
Changing Configuration Settings from the Display
You need to enter Setup mode before you can change configuration
settings. For more information on entering Setup mode and
navigating through the settings, see “Understanding Setup Mode”
on page 21.
The top levels of the Setup menu are organized in a one-way loop.
Each level has several sub-levels.
Options in Extended Test Mode
Function Description
Select Media This option is almost the same as the process in Test
mode, except that the printer performs a slow test
feed in Extended Test mode. The slow test feed
enables the printer to perform a slow sensor
calibration which can help resolve mark detection
problems.
Test Labels This option allows you to print test labels one at a
time. Press to print the next label.
Dump Mode This options enters Dump mode. For more
information on Dump mode,
see “Troubleshooting
Communication Problems” on page 60.
Factory Default This option restores the factory default settings. Press
to select this option and then follow the
instructions on the screen.
Exit to Setup This option exits Extended Test mode and puts the
printer in Setup mode.
Exit This option exits Extended Test mode.

Intermec PB22 Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Display	LCD
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Battery type	Built-in battery
Battery voltage	7.2 V
Bundled software	IPL, Fingerprint, ZSim (ZPLII Simulation), ESC-P, DSim
Media types supported	Labels
Operating temperature (T-T)	-15 - 50 °C
Operating relative humidity (H-H)	10 - 90 %
Harmonized System (HS) code	84433210

Weight and Dimensions

Depth	176 mm
Width	101 mm
Height	71 mm
Weight	678 g