EasyManuals Logo

Intermec PB22 User Manual

Intermec PB22
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #47 background imageLoading...
Page #47 background image
Chapter 2 — Configuring the PB22 and PB32
PB22 and PB32 Mobile Label and Receipt Printer User Guide 35
Setting Up 802.11 Radio Communications
The printer can have an internal 802.11 b/g radio to transfer and
receive data using wireless communications. This manual assumes
that you have already set up your wireless communications network
including your access points. These procedures include information
about setting up wireless security for both IPL and Fingerprint
versions of the printer.
The printer supports these authentication modes: none, WEP, WPA
Personal and Enterprise mode (802.1x authentication), WPA2
Personal and Enterprise mode (802.1x authentication).
To set up the printer to work in your wireless network, you need:
Serial cable (P/N 075497-xxx).
Host PC running Windows or Linux.
Active 802.11b or 802.11g wireless access point.
Communications application, such as PrintSet or HyperTerminal.
To set up the printer for wireless communications using PrintSet
1 Connect the 8-pin circular DIN connector to the serial port on the
printer. Connect the other end of the serial cable to a serial port on
your PC.
2 On your PC, start PrintSet.
3 Select your printer from the My Printers list. For more
information on how to add a printer to PrintSet, see To connect
the printer to a PC through the serial port using PrintSet” on
page 31.
Note: WPA and WPA2 Enterprise modes currently support PEAP,
TTLS, and LEAP. For LEAP authentication, the printer supports
Open EAP, but does not support Network EAP.
Note: If you are using IPL commands with HyperTerminal, you may
want to be able to see the commands as you type them on your
screen. For help, see “Changing Configuration Settings Using the
Command Line” on page 44.

Table of Contents

Other manuals for Intermec PB22

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intermec PB22 and is the answer not in the manual?

Intermec PB22 Specifications

General IconGeneral
Print technologyDirect thermal
Maximum resolution203 x 203 DPI
DisplayLCD
Standard interfacesRS-232, USB 2.0
Internal memory16 MB
Battery typeBuilt-in battery
Battery voltage7.2 V
Bundled softwareIPL, Fingerprint, ZSim (ZPLII Simulation), ESC-P, DSim
Media types supportedLabels
Operating temperature (T-T)-15 - 50 °C
Operating relative humidity (H-H)10 - 90 %
Harmonized System (HS) code84433210
Weight and Dimensions IconWeight and Dimensions
Depth176 mm
Width101 mm
Height71 mm
Weight678 g

Related product manuals