Intermec PB22

Chapter 2 — Configuring the PB22 and PB32
PB22 and PB32 Mobile Label and Receipt Printer User Guide 43
6 If you are using certificates for validation, here are some
commands you may need to use.
• Send these commands to set a certificate and enable validation:
setup "8021x","CA_CERT","c:/test.pfx@export"
setup "8021x","VALIDATE","ON"
where c:/test.pfx is the location and name of the certificate and
export is the passphrase.
• Send these commands to set a common name for server 1 and
server 2:
setup "8021x",".SERVER_CN1","xxxxxxxxxx"
setup "8021x",".SERVER_CN2","xxxxxxxxxx"
where xxxxxxxxxx can be a value from 0 to 64 characters.
• Send this command to make sure your values match those
used by the access point:
setup write "8021x","uart1:"
• You may need to send this command several times for the
wireless station to connect:
setup "wlan","ACTIVE","1"
Configuring the Printer Settings
You can change the configuration settings of the printer directly
from:
• the display.
• the host PC using PrintSet.
• the host PC using the command line.
• the printer home page.
• SmartSystems
TM
.
For more information about the IPL and Fingerprint menu systems,
see “IPL and Fingerprint Setup Menus” on page 83.