Intermec PB22 User Manual

Chapter 1 — Using the PB22 and PB32 Mobile Label and Receipt Printer
4 PB22 and PB32 Mobile Label and Receipt Printer User Guide
Understanding the Control Panel
The printer control panel contains four buttons, a liquid crystal
display (LCD), and one LED indicator. Use the four buttons to
navigate the menu system and perform functions on the printer.
Printer Control Panel
How to Use the PB22 and PB32 Buttons
Name Button Function
Feed Press to advance the media. The amount of media that
feeds is dependent on the type of media you are using.
It will advance by 5 mm (0.2 inch), or feed a configured
length of media based on your media and settings.
If the printer is printing, pressing this button causes
the printer to pause. Press the button again to resume
printing.
Setup Press to display the Setup menu. With ESC/P firmware,
press and hold to cancel printing.
Standby
(Power)
Press to put the printer in Standby mode. In Standby
mode, power to the radio, the display, and the
backlight are turned off.
Press to turn the printer back on and put in Ready
mode.
OK
SETUP:
SER-COM
Standby button Info button
Feed button
Setup button
Ready-to-Work
indicator

Intermec PB22 Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Display	LCD
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Battery type	Built-in battery
Battery voltage	7.2 V
Bundled software	IPL, Fingerprint, ZSim (ZPLII Simulation), ESC-P, DSim
Media types supported	Labels
Operating temperature (T-T)	-15 - 50 °C
Operating relative humidity (H-H)	10 - 90 %
Harmonized System (HS) code	84433210

Weight and Dimensions

Depth	176 mm
Width	101 mm
Height	71 mm
Weight	678 g