Intermec PB22 User Manual

Chapter 1 — Using the PB22 and PB32 Mobile Label and Receipt Printer
PB22 and PB32 Mobile Label and Receipt Printer User Guide 19
Printing on Floodcoated Media
If you are using colored media, also known as floodcoated media, you
may need to adjust the settings to enable better printing.
To configure the printer to print on floodcoated media
1 Press the Setup button.
2 Press until you reach Media.
3 Press to enter the Media menu system.
4 Press until you reach Advanced.
5 Press to enter the Advanced menu system.
6 Press until you reach Thermal Management.
7 Press to enter the Thermal Management menu system.
8 Press until you reach Custom TM.
9 Press to select Custom TM.
To adjust the print speed for floodcoated media
1 Press the Setup button.
2 Press until you reach Media.
3 Press to enter the Media menu system.
4 Press until you reach Advanced.
5 Press to enter the Advanced menu system.
6 Press until you reach Min Speed.
7 Press the Feed button to scroll through a list of numbers. Select a
number that is appropriate for the floodcoated media. To see a list
of sensitivity settings for each media type, go to “Recommended
Media Sensitivity and Constant” on page 71.
8 Press to select a number.
9 Reboot your printer.

Intermec PB22 Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Display	LCD
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Battery type	Built-in battery
Battery voltage	7.2 V
Bundled software	IPL, Fingerprint, ZSim (ZPLII Simulation), ESC-P, DSim
Media types supported	Labels
Operating temperature (T-T)	-15 - 50 °C
Operating relative humidity (H-H)	10 - 90 %
Harmonized System (HS) code	84433210

Weight and Dimensions

Depth	176 mm
Width	101 mm
Height	71 mm
Weight	678 g