Intermec PB22 User Manual

Chapter 2 — Configuring the PB22 and PB32
32 PB22 and PB32 Mobile Label and Receipt Printer User Guide
7 PrintSet attempts to connect to your printer. If it cannot find your
printer, click Back to review the communication settings, then try
again. When PrintSet connects to your printer, click Next.
8 Click Finish. Your printer appears in the My Printers list.
To connect the printer to a PC through the serial port using
HyperTerminal
1 Connect the 8-pin circular DIN connector to the serial port on the
printer. Connect the other end of the serial cable to a serial port on
your PC.
2 On your PC, start the communications program.
3 If necessary, configure the port settings so they match those of
your printer:
Bits per second: 115200
Data bits: 8
Parity: None
Stop bits: 1
Flow control: XON_XOFF
4 If you are using HyperTerminal:
a Click OK.
b Click the Settings tab.
c Click ASCII Setup. The ASCII Setup window appears.
d Select these check boxes:
• Send line ends with line feed
• Echo typed characters locally
• Append line feeds to incoming line ends
5 Click OK to save and exit ASCII Setup.

Intermec PB22 Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Display	LCD
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Battery type	Built-in battery
Battery voltage	7.2 V
Bundled software	IPL, Fingerprint, ZSim (ZPLII Simulation), ESC-P, DSim
Media types supported	Labels
Operating temperature (T-T)	-15 - 50 °C
Operating relative humidity (H-H)	10 - 90 %
Harmonized System (HS) code	84433210

Weight and Dimensions

Depth	176 mm
Width	101 mm
Height	71 mm
Weight	678 g