Goodrive200 inverters Function codes
Name
Detailed instruction of parameters
Default
value
adjustment when the frequency
achieves the upper and low limit；
feedback unless it reaches
the internal integral limit.
When the trend between the reference
feedback changes, it needs more time to offset the
working and the integration will
change with the trend.
1: Stop integral
adjustment when the frequency
reaches the upper and low limit. If the integration
keeps stable, and the trend between the
and the feedback changes, the integration will
change with the trend quickly.
LED tens:
0:The
same with the setting direction; if the output of
PID adjustment is different from the curre
direction, the internal will output 0 forcedly.
1:Opposite to the setting direction
P09.14
●
P10 Group Simple PLC and multi-step speed control
P10.00
0: Stop after running once. T
commanded again after finishing a cycle.
1: Run at the final value after running once. A
finish a signal, the inverter will keep the
frequency and direction of the last run.
2: Cycle running. The invert
until receiving a stop command and
0: Power loss without memory 0 ○
To Next Page
Loading...
