INVT Goodrive 200 - Page 164

Goodrive200 inverters Basic operation instruction
163
Set value
Function Instructions
13 Reserved
14 Overload pre-alarm
Output ON signal if the inverter is beyond the
pre-alarm point. Refer to P11.08~P11.10 for the
detailed instruction.
15 Underload pre-alarm
Output ON signal if the inverter is beyond the
pre-alarm point. Refer to P11.11~P11.12 for the
detailed instruction.
16 Simple PLC step completion
Output signal if the simple PLC step is completed.
17 Simple PLC cycle completion
Output signal if the 1 simple PLC cycle is
completed.
18 Set counting arrival
Output ON signal if the detected counting exceeds
the set value of P08.25.
19 Fixed counting arrival
Output ON signal if the detected counting exceeds
the set value of P08.26.
20 External fault valid Output ON signal if external fault occurs.
21 Length arrival
Output ON signal if the actual detected length
exceeds the se length by P08.19.
22 Running time arrival
Output ON signal if the accumulative running time
of the inverter exceeds the setting time by P08.27.
23
MODBUS communication
virtual terminal output
Output corresponding signal according to the
setting value of MODBUS. Output ON signal if the
setting value is 1 and output OFF signal if the
setting value is 0.
24~26 Reserved
27 Auxiliary motor 1 start
28 Auxiliary motor 2 start
Please refer to the detailed instruction of P18.09,
P18.10 and P18.11.
25~30 Reserved
Relative parameters list:
Function
code
Name Detailed instruction of parameters
Default
value
P06.00 HDO output
0:Open collector pole high speed pulse
output
0