INVT Goodrive 200 - Page 55

Goodrive200 inverters Function codes
54
Functio
n code
Name
Detailed instruction of parameters
Default
value
Modify
motor parameter will impact the control accuracy.
P00.16
AVR function
selection
0:Invalid
1:Valid during the whole prodecure
The auto-
adjusting function of the inverter can
cancel the
impact on the output voltage of the
inverter because of the bus voltage fluctuation.
1 ○
P00.17
Motor type
0:G type, for the constant torque load
of rated
parameters
1:P type; for the variable torque load
of rated
parameters (fans and water pumps)
GD200
series inverters can use G/P types, the
availabel motor power of G type is small one power
file than that of P type.
0 ◎
P00.18
Function
restore
parameter
0:No operation
1:Restore the default value
2:Clear fault records
Note: The function code wil
l restore to 0 after
finishing the operation of the selected function code.
Restoring to the default value will cancel the user
password, please use this function with caution.
0 ◎
P01 Group Start-up and stop control
P01.00
Start mode
0:Start-up directly:
start from the starting frequency
P01.01
1:Start-
up after DC braking: start the motor from the
starting frequency after DC braking (set the
parameter P01.03 and
P01.04). It is suitable in the
cases where reverse rotation may occur to the low
inertia l
oad during starting.
2: Start-up after speed tracking
: start the rotating
motor smoothl
y after tracking the rotation speed and
direction automatically. It is suitable in the cases
where reverse rotation may occur to the big inertia
load during starting.
0 ◎
P01.01
Starting Starting frequency of direct start-
up means the
0.50Hz
◎