INVT Goodrive 200 - Page 67

Goodrive200 inverters Function codes
66
Functio
n code
Name
Detailed instruction of parameters
Default
value
Modify
torque boost
P04.02
Motor 1
torque
boost
close
low frequency torque. P04.01 is for the Max. Output
voltage V
b
.
P04.0
2 defines the percentage of closing frequency
of manual torque to f
b
.
Torque boost should be selecte
d according to the
load. The bigger the load is
, the bigger the torque is.
Too big torque boost is inappropriate
because the
motor will run with over magnetic, and the current of
the inverter will increase
to add the temperature of
the inverter and decrease the efficiency.
When the torque boost is set to 0.0%, the
inverter is
automatic torque boost.
Torque boost threshold: below
this frequency point,
the torque boost is effective, but over this frequency
point, the torque boost is ineffective.
The setti
ng range of
P04.01:0.0%:(automatic)0.1%~10.0%
The setting range of P04.02:0.0%~50.0%
20.0%
○
P04.03
Motor 1 V/F
Frequency
point 1
0.00Hz
○
P04.04
Motor 1 V/F
Voltage
point 1
00.0%
○
P04.05
Motor 1 V/F
00.00Hz
○