INVT Goodrive 200 - Page 68

Goodrive200 inverters Function codes
67
Functio
n code
Name
Detailed instruction of parameters
Default
value
Modify
Frequency
point 2
P04.06
Motor 1V/F
V
oltage point
2
00.0%
○
P04.07
Motor 1V/F
Frequency
point 3
00.00Hz
○
P04.08
Motor 1V/F
V
oltage point
3
damage. The inverter may occur
the overcurrent
speed or overcurrent protection.
The setting range of P04.03: 0.00Hz~P04.05
The setting range of P04.04:0.0%~110.0%
The setting range of P04.05:P04.03~ P04.07
The setting range of P04.06:0.0%~110.0%(the rated
voltage of motor 1)
The setting range of P04.07:P04.05~ P02.02
(the
rated frequency of motor 1) or P04.05~ P02.16
(the
rated frequency of motor 1)
The setting range of P04.08:0.0%~110.0%(the rated
voltage of motor 1)
00.0%
○
P04.09
Motor 1 V/F
slip
compensatio
n gain
T
his function code is used to compensate the
change of the rotation speed caused by load during
compensation V/F control to improve the rigidity of
the motor. It can be set to the rated
slip frequency of
the motor which is counted as below:
△f=f
b
-n*p/60
Of which, f
b
is the rated
frequency of the motor, its
function code is P02.01; n is the rated rotating
speed
of the motor and its function code is P02.02；p
is the
pole pair of the motor. 100.0%
corresponds to the
rated slip frequency△f.
Setting range:0.0~200.0%
0.0%
○
P04.10
Motor 1 low
frequency
vibration
control factor
10 ○
P04.11
M
otor 1 high
frequency
vibration
In the V/F control mode, current fluctuation may
occur to the motor on some frequency, especially the
motor with big power. The motor can not run stably
or overcurrent may occur. These phenomena
can be
canceled by adjusting this parameter.
The setting range of P04.10:0~100
The setting range of P04.11:0~100
10 ○