INVT IPE300 Series - P07 Group-Human-Machine Interface

IPE300 series engineering VFD Function parameter list
-151-
Function
code
Name
Description
Default
Modify
P06.29
HDO output
upper limit
P06.27–100%
100.0%
○
P06.30
HDO output
corresponding to
upper limit
0.00–50.00Hz
50.00
kHz
○
P06.31
HDO output filter
time
0.000s–10.000s
0.000s
○
P06.32
Reserved
P06.33
Detection value
for frequency
being reached
0–P00.03
1.00Hz
○
P06.34
Frequency
reaching
detection time
0–3600.0s
0.5s
○
P07 group––Human-machine interface
Function
code
Name
Description
Default
Modify
P07.00
User password
0–65535
When you set the function code to a non-zero
number, password protection is enabled.
If you set the function code to 00000, the
previous user password is cleared and password
protection is disabled.
After the user password is set and takes effect,
you cannot enter the parameter menu if you enter
an incorrect password. Please remember your
password and save it in a secure place.
After you exit the function code editing interface,
the password protection function is enabled
within 1 minute. If password protection is
enabled, "0.0.0.0.0" is displayed when you
press the PRG/ESC key again to enter the
function code editing interface. You need to enter
the correct user password to enter the interface.
Note: Restoring the default values may delete
the user password. Exercise caution when using
this function.
0
○