Ioline FlexJet - Page 6

Figure 38. Carriage noise may indicate a dirty or faulty wheel ........................................ 50
Figure 39.
Replacing the fuse . ................................................................................................... 51
Figure 40.
A good transitor on the left; the one on the right is blown .......................... 52
Figure 41.
Testing the Y-Axis motor . ....................................................................................... 54
Figure 42.
Mechanical, electrical and electronic diagnostics ow chart . ......................... 61
Figure 43.
Removing the right end cover ............................................................................... 64
Figure 44.
Loosen the belt tensioner . ..................................................................................... 64
Figure 45.
The carriage cover screw . ...................................................................................... 65
Figure 46.
Unclip the belt from both ends of the carriage . ............................................... 65
Figure 47.
Loosen the carriage wheel lock . ........................................................................... 66
Figure 48.
Gently press down on the carriage . .................................................................... 66
Figure 49. Rotate the v-wheels free of the traverse rail . ................................................... 66
Figure 50.
Carriage installation . ................................................................................................ 67
Figure 51.
Use the spacer when attaching each swing arm . .............................................. 67
Figure 52.
The carriage belt tensioner . .................................................................................. 68
Figure 53.
Install the carriage cover . ....................................................................................... 68
Figure 54.
Remove the cover .................................................................................................... 69
Figure 55.
Install the carriage cover . ....................................................................................... 70
Figure 56.
Remove the logic board cover plate .................................................................... 70
Figure 57.
Unplug the feed motor and encoder cables from the logic board . .............. 71
Figure 58.
Unplug the ribbon cables . ...................................................................................... 71
Figure 59.
Make a loop in the ribbon cable to the left of the carriage . .......................... 72
Figure 60.
Carriage installation . ................................................................................................ 73
Figure 61.
The carriage belt tensioner . .................................................................................. 73
Figure 62.
Install the carriage cover . ....................................................................................... 74
Figure 63.
There should be a small gap in the ribbon cable loop . .................................... 75
Figure 64.
The loop in the cable should not touch the left endplate . ............................. 75
Figure 65.
Secure the sleeving with tape . ............................................................................... 76
Figure 66.
Remove the right end cover . ................................................................................. 77
Figure 67.
Remove the screws and let the keypad hang ..................................................... 77
Figure 68.
Remove the carriage cover . ................................................................................... 77
Figure 69.
Install the ink cartridges and turn the power on . ............................................. 78
Figure 70.
Loosen the carriage catch bracket . ...................................................................... 78
Figure 71.
Cover the spit wells . ............................................................................................... 78
Figure 72.
Two lines in the spit well holes . ............................................................................ 79
Figure 73.
Use the plastic thumbscrew to adjust the lines if necessary . ........................ 79
Figure 74.
Y Fine adjustment is performed within the Control Center . .................... 80
Figure 75.
Watch the gap between the carriage and Service Station . ........................80
Figure 76.
The Service Station stop screw . ...................................................................... 81
Figure 77.
Small gap between the screw and the Service Station . .............................. 82
Figure 78.
Tighten the nut to hold the stop bracket . .......................................................... 82
Figure 79.
Unplug the take-up motor . .................................................................................... 83
Figure 80.
Remove the right cover . ......................................................................................... 83
Figure 81.
Unscrew the PCB cover . ........................................................................................ 83