iPECS UCM
Installation Manual Issue 1.1
Regulatory Information
Before making connections to the telephone network, you may be required to notify your local serving
telephone company of your intention to use "customer provided equipment.” You may further be required to
provide any or all of the following information:
PSTN Telephone numbers to be connected to the system.
Model name: iPECS UCM
Local regulatory agency registration number: locally provided
Ringer equivalence: 0.7B
Cable connector: Champ cable connectors (32 pairs)
This equipment complies with the following regulatory standards, that is, the safety requirements of EN60950-
1, and the EMC requirements of EN55032 and EN55024.
If the telephone company determines that customer provided equipment is faulty and may possibly cause
harm or interruption in service to the telephone network, it should be disconnected until repair can be affected.
If this is not done, the telephone company may temporarily disconnect service.
The local telephone company may make changes in its communications facilities or procedures. If these
changes could reasonably be expected to affect the use of the iPECS UCM or compatibility with the network,
the telephone company is required to give advanced written notice to the user, allowing the user to take
appropriate steps to maintain telephone service.
The iPECS UCM complies with rules regarding radiation and radio frequency emission as defined by local
regulatory agencies. In accordance with these agencies, you may be required to provide information such as
the following to the end user
European Union Declarations of Conformity
Ericsson-LG Enterprise Co.,Ltd. declare that the equipment specified in this document bearing the “CE” mark
conforms to the European Union Radio Equipment Directive(RED, 2014/53/EU), including the Electromagnetic
Compatibility Directive(EMCD,2014/30/EU) and Low Voltage Directive(LVD, 2014/35/EU). Copies of these
Declarations of Conformity (DoCs) can be obtained by contacting your local sales representative
FCC/CSA Interference Statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct the interference at
their expense.
This device complies with part 15 /RSS-GEN of the FCC/IC rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference; and (2) This device must accept any interference received,
including interference that may cause undesired operation.
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
To Next Page
Loading...
