iPECS UCM - Page 3

iPECS UCM
Installation Manual Issue 1.1
This Class A digital apparatus meets the requirements of the Canadian Interference-Causing Equipment
Regulations, CAN ICES-3(A)/NMB-3(A)
Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel brouilleur
du Canada.
The use of this device in a system operating either partially or completely outdoors may require the user to
obtain a license for the system according to the Canadian regulations. For further information, contact your
Local Industry Canada office.
Any changes or modifications in construction of this device that are not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
CAUTION
ATTENTION: Tout changement ou modification dans la construction de cet appareil qui ne sont pas
expressément approuvé par la partie responsable de la conformité pourraient annuler l'autorité de l'utilisateur
à utiliser l'équipement.
This is a class “A” product. In a domestic environment this product may cause radio interference in which case
the user may be required to take adequate measures.
WARNING
WARNING
This system employs a Lithium battery as back-up power for the real-time clock and memory. Risk of
Explosion if Battery is replaced by an Incorrect Type. Dispose of Used Batteries According to the
Instructions.
WARNING
This equipment generates and uses R.F. energy, and if not installed and used in accordance with the
Instruction Manual, it may cause interference to radio communications. It has been tested and found to
comply with the appropriate limits for a telecommunication device. The limits are designed to provide
reasonable protection against such interference, when operated in a commercial environment. Operation
of this equipment in a residential area could cause interference, in which case the user, at his own
expense, will be required to take whatever measures may be required to correct the interference.
- Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can
result in an explosion;
- Leaving a battery in an extremely high temperature surrounding environment that can result in an
explosion or the leakage of flammable liquid or gas;
- A battery subjected to extremely low air pressure that may result in an explosion or the leakage of
flammable liquid or gas.
- This system with a lithium battery must be operated below 2000m altitude.
Di spo sal of Old Appliance